Comfort Automation/ Security System Forums > Products > KT03 Touchscreen Keypad (OBSOLETE) > the "Zone Name" Element |
Comfort Automation/ Security System Forums > Products > KT03 Touchscreen Keypad (OBSOLETE) > the "Zone Name" Element |
| Moderated by: admin | ||
| Author | Post | |||||||||
|---|---|---|---|---|---|---|---|---|---|---|
|
slychiu Administrator 
|
The new Zone Name Element introduced in KT03 7.070 (requires Comfigurator 3.10.4) is used to display the zone name which last triggered an Alarm or the last open zone when attempting to arm the system (Arm Fail) This is used after an alarm is triggered to see which zone triggered the alarm. If several zones were triggered then the last zone will be displayed The Zone Name Element can be found in the screen ("Z" below circled in red) Click on the Z and place this element on a page and set the boundary of the element. It will initially appear blank until a zone is triggered in alarm  The plain text of the zone name will be shown in this box KT 7.070 firmware is required Comfigurator 3.10.4 software required to configure Zone Name Element Last edited on Monday May 25th, 2015 05:24 pm by slychiu |
|||||||||