UCM 7.069/7.072/7.075/7.076 - UCM Firmware - Products - Comfort Automation/ Security System Forums

Comfort Automation/ Security System Forums Home

Comfort Automation/ Security System Forums > Products > UCM > UCM Firmware > UCM 7.069/7.072/7.075/7.076

Moderated by: ident

Author

Post

slychiu
Administrator

Joined:	Saturday Apr 29th, 2006
Location:	Singapore
Posts:	5500
Status:	Offline

UCM 7.069

Added b?00 query all zones bypass state, reply b?00zzzz where each bit is a zone bypass state.
add Ke command for KT03 write system properties in sector

Last edited on Thursday Dec 17th, 2015 04:46 pm by slychiu

slychiu
Administrator

Joined:	Saturday Apr 29th, 2006
Location:	Singapore
Posts:	5500
Status:	Offline

UCM 7.072 changes

Fixed Bug log out on UCM/ETH03 on both ports did not disable Priority polling for UCM/Zwave for Comfort apps

slychiu
Administrator

Joined:	Saturday Apr 29th, 2006
Location:	Singapore
Posts:	5500
Status:	Offline

UCM 7.075
Fixed a bug found in certain combinations of modules where Comfigurator logs in and gets an NA reply during the initial queries. Firmware released

Known BUGs

COPY Button set ID could not set to maximum 8 From UCM 7.072
If an empty message is sent to the UCM serial port (by Comfigurator or other software), it will cause the UCM to hang. The UCM must be reset

Last edited on Sunday Apr 15th, 2018 10:20 am by slychiu

slychiu
Administrator

Joined:	Saturday Apr 29th, 2006
Location:	Singapore
Posts:	5500
Status:	Offline

UCM 7.075 Bug

If an empty message is sent to the UCM serial port (by Comfigurator or other software), it will cause the UCM to hang. The UCM must be reset

slychiu
Administrator

Joined:	Saturday Apr 29th, 2006
Location:	Singapore
Posts:	5500
Status:	Offline

UCM 7.076 fixes the bug in 7.075 where the entry of a message with no content causes the UCM to hang.
This is not likely to occur using Comfigurator or other software like Comfortclient or the Comfort mobile and tablet apps. However the firmware should be upgraded nevertheless