When Zone Restore Box is checked, meaning when the zone is restored following an alarm, it may not report the zone restore to CMS or GSM in some cases. From 7.059
Changes from 7.068
Wait for Timer delay action 190 - if timer value=0000, use last action value as timer value. This allows values returned from previous actions to be used as the timer delay in seconds.
When Keypad broadcast announcement is disabled, if there is a full alarm (alarmstate=3), the keypad broadcast is re-enable so that the alarm sounds can be heard on all keypads.
If a counter value is changed by a UCM, Comfort will broadcast the counter change to other UCMs, but the UCM which originated the counter change will ignore the counter change, so as to avoid the UCMs counter getting changed again which may cause race effects with certain systems (like Zwave dmming) broadcast. This requires UCM of each type firmware 7.068
Multiply action - fixed BUG check wrong limit. intermediate result of multiplication of 2 x 32 bit values if > 32767 gives wrong result.
Actions Add counter, Add counter give wrong answer from 7.039
Sentence upgrade without vocab upgrade does not work, but Full vocabulary upgrade upgrade works.
If telephone line not connected, and Ignore Line Cut Box is unchecked then alert zone will cause an immediate alarm - This is an old bug. To work around, check "Ignore Line Cut" Box in Security > Configuration Flags
Action 73, 16 Get keypadId/ If Keypad ID does not work
Changes and New Features
Fixed Bug - Deg C/F always was set to deg F in Location 39 (This feature is not used in Comfort yet
Fix BUG from firmware 6.010 caused F? Query replied FL. Flag query did not return the correct value after reset. Flag states are not changed by soft reset, but F? Always Returns off after reset.
Fixed bug DA09 followed by phone offhook causes tone to be generated until reset.
Sign in tamper can only be reset by local ie keypad or phone, not from UCM as that may come from Internet. Only 1 correct sign in from local phone or keypad resets sign in tamper
Arming/disarming fixed problem when system is arming with zones open, but is disarmed without arming,when zones are restored, the restore zones are reported to cms and sms.
Logic engine Firmware can bypass and unbypass zones
Last edited on Sunday Nov 5th, 2017 11:05 am by slychiu