Moderated by: admin |
Author | Post | |||||||||
---|---|---|---|---|---|---|---|---|---|---|
mikegriff Member
|
Hi Chiu. Is there a way of me setting the Baud Rate to 57600 on a UCM Universal? Thanks in advance! Mike. |
|||||||||
ident Administrator
|
Currently the baud rates available are 2400, 4800, 9600, 19200, 38400, 76800 Other baud rates may be possible if the firmware is changed Which devices requires 57600 which is not a common baud rate? |
|||||||||
Ingo UCM Pi Users
|
Actually these are the most commonly supported ones. 76800 is an odd one. "Bit rates commonly supported include 75, 110, 300, 1200, 2400, 4800, 9600, 19200, 38400, 57600 and 115200 bit/s." |
|||||||||
juwi_uk Member
|
Isn't all that largely irrelevant though; I thought the ETh3 to base board serial conversion was locked to 9600 so there is no advantage of upping the ETh3 side speed? J |
|||||||||
ident Administrator
|
The baud rates are applicable to Rs232 and RS485 submodule on UCM/Universal For ETH03, the baud rates in the Universal UCM still apply, but when converted to TCP/IP the speed becomes irrelevent ETH03 serial speed is not limited to 9600 baud, but the Comfort Bus is fixed at 9600 baud |
|||||||||
mikegriff Member
|
I'm trying to control my sky boxes I already have software which works so i don't really want to alter the Baud rate on the control unit. http://www.dusky-control.com/serial.shtml But it would be really useful to have comfort to do it especially with Julian's ComfortClient http://www.dusky-control.com/serial-protocol.shtml Thanks Mike |
|||||||||
tman Comfort Distributors
|
Why not just alter the baud rate on the box? You're not going to be connecting to it from Comfort and your software at the same time. If you ever need to switch then just set the baud rate again. |
|||||||||
mikegriff Member
|
because it is a real pain. you have to connect a Pc putty or whatever to the control box send the string 'ProGraMmoDEB8' reboot the control box disconnect PC reconnect to comfort Have a play and then do the reverse. If it was possible to change it in firmware it would be great! Mike Last edited on Monday Aug 11th, 2014 02:50 pm by mikegriff |
|||||||||
ident Administrator
|
It may be possible to change it in firmware but that will not be for some time as we are working on other projects and will not be able to look into this for some time Changing the baud rate om the skybox seems the more practical option |
|||||||||
mikegriff Member
|
OK But it would be really good to add 57600 perhaps instead of 2400? Mike |
|||||||||
mikegriff Member
|
v7.065 Thank you for sorting the 57600 baud rate Chiu Much appreciated Mike |