| Moderated by: admin | ||
| Author | Post | |||||||||
|---|---|---|---|---|---|---|---|---|---|---|
|
MDKKEN Member
|
Hi,
|
|||||||||
|
ident Administrator 
|
Yes You can use Universal UCM + ETH03 for Lightwave RF |
|||||||||
|
carrington Member
|
Hi, I would like to do this - can I just check that I should download the UDP firmware for ETH02 and apply to ETH03 and follow the instructions in the App note? Thanks! |
|||||||||
|
ident Administrator
|
Eth03 is a different hardware platform from eth02 so the firmware is not interchangeable |
|||||||||
|
tman Comfort Distributors
|
carrington wrote: Hi, Use the ETH03 universal firmware if you have an ETH03. The ETH02 and ETH03 are completely different modules and the firmware is not compatible between them. |
|||||||||
|
carrington Member
|
Thanks that is what I had assumed, it seemed unlikely. But I am not sure which parts of the LightwaverfAppNote.pdf are applicable? Do I just pickup at the "Comfigurator Programming" (page 9)? If so how do I programme the Wifilink IP address into the comfort? The steps described seem specific to the ETH02 device? |
|||||||||
|
admin Administrator 
|
The lightwave RF application note was written for the ETH02 ETH03-Universal 1.15 supports UDP However there is a problem with Lightwave They have changed their registration method with their new firmware Regsiitration was by sending a lighting on or off command from the UCM but now a registration code is required, and that code has changed several times We will send some instructions on how to go ahead But it i quite worrying that their API commands have changed without warning |
|||||||||
|
carrington Member
|
I agree that the unannounced API change is concerning however do you have a date when you can expect to release the revised instructions? |
|||||||||
|
tech07 Administrator
|
Originally, to register the UCM/Universal to Lightwave, you had to send any command from it while pairing Now you have to send the string 001,!F*p\n Add comma "," before any command in comfigurator response, such as turn on room 1 device 1, ,!R1D1F1\n This was not disclosed by Lightwave, it was detected by using wireshark |
|||||||||
|
tech07 Administrator
|
I forgot to say you need ETH03 Universal 1.15 firmware to support Lightwave for eth03 Download from http://www.cytech.biz/eth03_firmware.html select UDP For multiple commands into a single response, the correct format is : !FePâ€<sequence name>â€=<command>,<delay> ,( <command>,<delay> eg 001,!FeP"Test"=!R1D1F1,00:00:03,!R1D3F1<cr> or !FeP"Test"=!R1D1F1,00:00:03,!R1D3F1<cr> Last edited on Saturday Oct 11th, 2014 09:09 am by tech07 |
|||||||||