Posted: Thursday Apr 3rd, 2014 12:34 pm |
|
1st Post |
agenor
Comfort Installers
Joined: | Thursday Apr 21st, 2011 |
Location: | Rijeka, Croatia |
Posts: | 86 |
Status: |
Offline
|
back to top
|
Hello!
As trivial a question as it may seem, but - where from do we download the .knxprod file for the ETS4 KNX programming software? Without it, the ETS4 doesn't recognize the UCM/KNX.
Thanks!
|
Posted: Thursday Apr 3rd, 2014 03:25 pm |
|
2nd Post |
ident
Administrator
Joined: | Wednesday Aug 9th, 2006 |
Location: | Singapore |
Posts: | 3493 |
Status: |
Offline
|
back to top
|
The UCM/KNX is not like a KNX device, it is not programmmed by ETS
You program in Comfigurator by mapping the group addresses to Comfort counters, sensors, virtual inputs and other registers
The UCM/KNX manual will explain in detail. download from http://www.cytech.biz/ucmknx_manual.html?category_id=107
|
Posted: Thursday Apr 3rd, 2014 03:32 pm |
|
3rd Post |
agenor
Comfort Installers
Joined: | Thursday Apr 21st, 2011 |
Location: | Rijeka, Croatia |
Posts: | 86 |
Status: |
Offline
|
back to top
|
OK, so this means that the unit cannot even be defined in the ETS software (so that it is known that there's a device with that individual address)?
Thanks!
|
Posted: Thursday Apr 3rd, 2014 03:45 pm |
|
4th Post |
ident
Administrator
Joined: | Wednesday Aug 9th, 2006 |
Location: | Singapore |
Posts: | 3493 |
Status: |
Offline
|
back to top
|
Correct, but there is little benefit to be able to see it in KNX from what I can see
|
|