Comfort Automation/ Security System Forums > Support > Comfort Installation and Programming Guide > Responses and Actions > Checking the state of Flags, Counters, Sensors, Zones, Outputs |
Comfort Automation/ Security System Forums > Support > Comfort Installation and Programming Guide > Responses and Actions > Checking the state of Flags, Counters, Sensors, Zones, Outputs |
| Moderated by: admin | ||
| Author | Post | |||||||||
|---|---|---|---|---|---|---|---|---|---|---|
|
ident Administrator 
|
You can check the state or value of Counters, Sensors, Flags, Outputs and Inputs in Comfigurator Counters, Sensors and Flags are used in Logic Programming in Comfort. These are very useful tools in programming Comfort It is useful to be able to find out the state of these elements in order to debug the program Eg If Flag 1=0 and Counter 010>40, then Do All Lights Off The Show Status checkbox in various screens causes Comfigurator to show the states Eg the Flags screen is shown below  All Flag values are shown at the same time, and any change in flag status is shown immmediatelty In the Counter screen, each counter has its own Show Status box, so you select each Counter that you want to show the value   The Counters which do not have "Show Status" enabled have the value "Unknown" Last edited on Sunday Jun 30th, 2013 01:30 pm by ident |
|||||||||