Moderated by: ident |
Author | Post | |||||||||
---|---|---|---|---|---|---|---|---|---|---|
ident Administrator
|
This firmware upgrade is important due to the last point above. UCM firmware version 7can be upgraded by Bus as well as by direct connection (by USB, ETH02 or RS232). When the upgrade by Bus fails for any reason (except for lost ethernet connection), it should be possible to repeat the upgrade by Bus. However, for older UCM firmware versions the UCM which failed upgrade wiill report as version 6.000, so Comfigurator will not allow the repeat of firmware upgrade because only firmware version 7 can be upgraded. The new firmware 7.016 will report its firmware as 7.000 instead of 6.000 so the upgrade can be repeated. This same issue applies to KT03 firmware which can be upgraded by Bus. There is a new Firmware KT 7.016 which fixes this potential problem Last edited on Monday Apr 8th, 2013 05:30 am by ident |
|||||||||
slychiu Administrator
|
Clarification on how the UCM firmware upgrade by Bus can fail;
However it is quite unlikelly that the firmware upgrade will fail If there is a loss of ethernet connection for UCM/ETH02 Comfigurator 3.6.5 will ask "Do you want to continue from the last address". If you select OK, the upgrade will continue so this situation is not a problem. This is the more likely scenario |