The Monitor Mode tab in the KNX Comfigurator allows incoming telegrams from KNX to be displayed.
In Monitor mode, the KNX to Comfort mapping does NOT work
If you leave the Monitor tab that ends the monitor mode and KNX to Comfort commands will work again
However, we have found that if you log out or close comfigurator without leaving the monitor mode tab, then the UUCM/KNX remains in Monitor mode and KNX to Comfort commands will NOT WORK
We shall try to fix this in Comfigurator (currentlly 3.6.4)
In the meantime, please ensure that you leave Monitor mode always before leaving the UCM/KNX
The UCM/KNX Manual has been updated with this warning
http://www.cytech.biz/ucmknx_manual.html?category_id=107
Last edited on Tuesday Feb 19th, 2013 01:07 am by ident
|