Comfort Automation/ Security System Forums > Products > UCM > Clarity on UCM firmware upgrade options |
Moderated by: slychiu |
Author | Post | |||||||||
---|---|---|---|---|---|---|---|---|---|---|
idheath Member
|
I had the following: Comfort II Ultra: 6.020 UCM/ETH02 6.012 UCM/232 6.0.12 I use Comfigurator via the UCM/ETH02 and have just upgraded to the following, in the order shown (using Comfigurator): UCM/ETH02 6.024 Comfort II Ultra: 6.028 My query is how can I upgrade the UCM/232? It is not connected to a PC. I assumed I could use the "For module connected to Comfort Bus" option in Comfigurator but only the Controller is shown in that option. |
|||||||||
ident Administrator
|
The UCM currently can only be upgraded by direct connection to a PC In a future firmware upgrade, UCMs will be upgradeable both by Bus and Direct connection For now you can just swap the ETH and RS232 submodules and upgrade the UCM by ETH02 |
|||||||||
idheath Member
|
ident wrote:The UCM currently can only be upgraded by direct connection to a PC Thanks for the clarification |