Posted: Thursday Aug 16th, 2012 03:44 pm |
|
1st Post |
MJC Electronics
Member
Joined: | Friday Aug 29th, 2008 |
Location: | |
Posts: | 19 |
Status: |
Offline
|
back to top
|
Hi
I've just replaced my main KP04 with a KT03.
The versatility of this is great but having to move a laptop to the front door every time I want to add a new feature is a real pain, not to mention the constant removal and refitting of the bezel.
Is there any chance you could move to remote programing of the KT03 over the bus at some point in the future, just like the firmware is now?
|
Posted: Friday Aug 17th, 2012 02:30 am |
|
2nd Post |
ident
Administrator
Joined: | Wednesday Aug 9th, 2006 |
Location: | Singapore |
Posts: | 3493 |
Status: |
Offline
|
back to top
|
That is a timely question. because R&D have been working on remote read/write of the KT03 through the UCM. This will be much slower than direct connection to the KT03 USB port, so a typical file may take 10 minutes or more.
This will require all new firmware for UCM, Comfort and KT03 to be 6.050 or above when they are released as well as a new Comfigurator version
|
Posted: Friday Aug 17th, 2012 12:05 pm |
|
3rd Post |
ndh
Comfort Installers
back to top
|
This will be very useful as I have indicated before.
If you remotely alter a response in Comfort it will become unfixed and the KT03 will now be out of synch and probably not work properly. (Particularly useful for installations in Malta .....)
|
|