Comfort Automation/ Security System Forums > Support > Problems & Troubleshooting > Arming and Disarming > Arming: suppress zone announcements and volume of arming tone |
Moderated by: admin |
Author | Post | |||||||||
---|---|---|---|---|---|---|---|---|---|---|
HenleyBranch UCM Pi Users
|
Hi Is there a way to suppress zone announcements and increase the arming tone volume during arming? Henley |
|||||||||
ident Administrator
|
In KP03 and KP04 you can only turn down the volume to reduce zone announcements In KP06 you can turn off all announcements |
|||||||||
HenleyBranch UCM Pi Users
|
I have a PIR in the hallway and a sensor on the final door - when arming and disarming I would prefer to have just the beeps from the keypad - rather than the announcement of those zones which is confusing for users. I was wondering if there would be a way with the Start Arming response, but I can't figure out a way of supressing zone announcements temporarily. Henley |
|||||||||
ident Administrator
|
There is an action Keypad announcement Disable whecih can be used to disable keypad announcement on anu ID and you can enable it again usng a Response |