Comfort Automation/ Security System Forums > Third Party (interfacing to Comfort) > KNX (EIB) > KNX Support > 1 bit Arm to Away group address seems not working |
Moderated by: ident |
Author | Post | |||||||||
---|---|---|---|---|---|---|---|---|---|---|
TheMax74 Member
|
Map 1 bit Arm to Away to a group address seems not working. Sending "1" from KNX bus to this group, does nothing in Comfort. Can you check please? Thanks. |
|||||||||
slychiu Administrator
|
This is the most commonly used function for KNX which should definately work Can you send your cclx file to support@cytech.biz |
|||||||||
TheMax74 Member
|
No, thanks, i will investigate more. Shure is my mistake. Thank you. |
|||||||||
Canha Member
|
Try updating the firmeware...it worked for me.. |
|||||||||
TheMax74 Member
|
Thanks |
|||||||||
Tan121 Member
|
I seem to have the same problem after updating the firmware. Before it worked fine. Now I have all the modules last firmware and Comfort is sending time to KNX but Night Arming from KNX does not work. |
|||||||||
ident Administrator
|
Did you WRITE to EEPROM for the UCM/KNX? |
|||||||||
ident Administrator
|
We have confirmed that there is a bug in Comfort firmware 6.006, which causes the 1-bit arm from KNX not to work, see http://www.comfortforums.com/forum79/2571.html Please downgrade to ULT 6.005 for the time being We are working on a new firmware release to fix this problem |
|||||||||
TheMax74 Member
|
Thanks. |
|||||||||
ident Administrator
|
We have found and fixed the bug in Comfort which causes the 1-bit arming not to work. Now we are doing intensive testing of the firmware which will take some time The firmware ULT 6.009 is attached for those who would like to try it out for themselves before the release See forum for Ultra beta firmware 6.009 http://www.comfortforums.com/forum79/2637.html Last edited on Saturday Dec 10th, 2011 04:07 am by ident |