Sorry if this is easy but am new to this. I have now got my comfort alarm system functioning correct apart from one thing. While testing my set-up to see if it all worked OK I purposely caused an alarm. This caused the bell and strobe to operate but when I enter my code to re-set the alarm I can not stop the strobe. I have reset comfort from comfigurator and this doesn’t work either. At the moment the only way I can stop the strobe once the alarm has gone off is to disconnect the battery and mains power.
Any advice would be much appreciated.
Update - I thought the strobe was only going on after the alarm had been triggered but the strobe is always on when it has power.....
Last edited on Friday Sep 9th, 2011 06:54 pm by strickers