Comfort Automation/ Security System Forums > Support > Problems & Troubleshooting > Arming and Disarming > Arm Failure Z |
Moderated by: admin |
Author | Post | |||||||||
---|---|---|---|---|---|---|---|---|---|---|
m.khairy Member
|
I upgraded Firmware to 6.005 using the UCM usb but when i armed the system to away mode the arm failure & the message appare on keypad : arm failure z i isolated all I/O except by one I/p on the main board and the problem is still |
|||||||||
ident Administrator
|
When you armed to away mode did it arm completely? Do you mean there was an arm failure which prevented it from arming? Did you open and close the entry door? Exactly what happened when you tried to arm to away? |
|||||||||
m.khairy Member
|
when i armed to away mode it armed completely then automatically turned to security off after one second and got the fast beeps this problem is found in three sites that i work in |
|||||||||
WMADKOUR Comfort Installers
|
observe reply |
|||||||||
ident Administrator
|
Yes, I suspect that you did not open and close the front door. When you arm to Away Mode, in order to complete arming, you must exit the house, ie go out of the front door and close it. This allows the system to arm to away mode Away Mode means that everyone is Away from the house. you do not arm to Away Mode and stay in the house. Otherwise you should arm to Night Mode See the post on Arming to Away Mode at http://www.comfortforums.com/forum16/2367.html |
|||||||||
m.khairy Member
|
but the zone type of the only zone that i connected is DoorWindow Not EntryDoor |
|||||||||
ident Administrator
|
Are you saying that you do not have a alarm contact on the entry door that can act as an Entry Door Zone Type? It is advisable to always have an entry door Zone, so that it can end the exit delay and arm after the door has closed. The doors and windows on the ground floor should have contacts as these are the primary alarm protection. It is not good to rely on the PIRs or motion detectors as the main alarm detection because these only work when the intruder is inside the house. Furthermore, motion detectors may have to be disabled when people are in the house to prevent alarms so it may prevent you from arming to Night Mode. If you really cannot fix the alarm contact on the entry door then you should set the Away Arming Method in Security > Arming and Disarming to After Exit Delay The options for Away Arming Method are
|
|||||||||
m.khairy Member
|
The reason for not being able to arm wasn't expected i choose the away arming method (final door) & did not open and close the door so the system wasn't able to go to away mode when i choose away arming method (after exit delay) the system went to away mode & work correctly Thanks Very much |