Version 6.007 (1 Aug 2011)
- Supports Firmware upgrade via Comfort Bus with Comfigurator 3.3.x
- Fixed BUG DT query does not get reply.
- Send RSxx were xx is id to PC when reset
- Improvements in handling errors in the command sequence in UCM upgrade by direct connection to PC. Error message UBF2 is sent when an unknown command is received by UCM during upgrade process, this means the upgrade must be done again
- UCM firmware upgrade implemented time-out for program and erase and verify check for each location, gives error UBF6-AAAAAA-DD
This firmware mainly improves on error handling during the UCM firmware self upgrade by direct connection to Comfigurator
Please download the firmware from http://www.cytech.biz/ucm_firmware.html
Note that if a firmware upgrade error occurs for any reason eg
- Comfigurator crash
- Loss of communications
- error message during upgrade
- any other reason
Please DO NOT reset the UCM if there is any error as this may cause the firmware to be corrupted, requiring the UCM firmware to be upgraded using the UCM Programming cable
Always repeat the Firmware Upgrade via direct connection to Comfigurator again until it succeeds.
Do not try to upgrade the firmware via Ethernet for the time being due to potential problems caused by delays in the network
Last edited on Sunday Aug 14th, 2011 09:09 am by
|