| Posted: Sunday Oct 1st, 2006 11:24 am |
|
1st Post |
garym999
Member
back to top
|
I have one remaining C2 system out there on pre 5.054 firmware, just waiting to be upgraded. I have now had a message from the client to say the unit has locked up with "commiunications failure" on the keypad. Also the keypad will not respond to any keypresses
As I have remote VPN access I have tried talking to the comfort via ethernet. While I can ping its interface OK. I cannot logon.
After getting the customer to disconnect the battery and cycle the mains power to reset the system. I can now log on. The event log shows the following...
09/19 00:00 Reset
09/19 00:00 Sign in - User #
09/19 00:00 Mode Change #Security Off
09/19 00:00 RS485 tamper #Comfort Controller
09/19 00:00 Alarm Type #AlarmAbort (20)
09/19 00:00 Sign in - User #1
09/19 00:00 Mode Change #Security Off
09/19 00:00 Sign in - User #1
09/19 00:07 Reset
09/19 00:07 Sign in - User #
09/19 00:07 Mode Change #Security Off
The RS485 tamper explains the communications failure on the keypad and my in ability to login over the ethernet UCM. Is this a symptom of the bug or could I have another problem?
|
| Posted: Sunday Oct 1st, 2006 12:58 pm |
|
2nd Post |
slychiu
Administrator
| Joined: | Saturday Apr 29th, 2006 |
| Location: | Singapore |
| Posts: | 5500 |
| Status: |
Offline
|
back to top
|
This may be caused by the bug on the recorded messages
Can you tell the user to erase all messages, in user menu press 2 for messages, 3 to erase saved messages.
|
| Posted: Sunday Oct 1st, 2006 03:27 pm |
|
3rd Post |
garym999
Member
back to top
|
Thanks for the prompt reply. I'll pass the info on and make an effort to get the firmware changed. I have it here just need to sort a visit.
I guess this is for Comfort V3 but would be great if this could have been flashed via the serial or ethernet UCM.
|
| Posted: Monday Oct 2nd, 2006 02:18 am |
|
4th Post |
slychiu
Administrator
| Joined: | Saturday Apr 29th, 2006 |
| Location: | Singapore |
| Posts: | 5500 |
| Status: |
Offline
|
back to top
|
Unfortunately the CPU does not have flash, but we are working on such a feature for next year. You cannot have everything you want at one time 
|
| Posted: Monday Oct 2nd, 2006 10:05 am |
|
5th Post |
garym999
Member
back to top
|
You know us lot we want everything, Hence for comfort v3.
I'm sure we all would have a load of input for that. As time gets closer may be there should be a seperate forum to help address and prioritise our needs.
|
| Posted: Monday Oct 2nd, 2006 10:30 am |
|
6th Post |
|
