Comfort Automation/ Security System Forums > Third Party (interfacing to Comfort) > KNX (EIB) > KNX Support > Control groups cannot send KNX commands |
Moderated by: ident |
Author | Post | |||||||||
---|---|---|---|---|---|---|---|---|---|---|
ekarak Member
|
Strange problem with UCM/KNX: Comfort appears to communicate properly with KNX (ETS bus monitor shows alarm events, zones being opened etc.), comfort responds to KNX events (rain sensor triggers reminder message etc.) but KNX commands in reponses in the control groups do nothing. Strangest of all: manual execution of KNX responses from Comfigurator work fine!!! UCM/KNX version 5.213, main board is 5.202 |
|||||||||
ekarak Member
|
problem fixed, did a full reprogramming and reset and it worked. |
|||||||||
slychiu Administrator
|
Dont forget to do a Write to EEPROM in the KNX configurator as well as a Write to Comfort. Let us know if it happens again |