Comfort Automation/ Security System Forums > Support > Problems & Troubleshooting > Comfort I Issues > "Use Branch Actions" in Comfort I Ultra |
Moderated by: admin |
Author | Post | |||||||||
---|---|---|---|---|---|---|---|---|---|---|
ident Administrator
|
This applies to Comfort I and Comfigurator 2 only In Comfort I from firmware 4.233 onwards please check the box "Use Branch Actions" in Configuration > Modules & Settings if you use Comfigurator 2. This allows If/Then actions to work correctly for nested If/Then conditions. For example, see the Response below. If Use Branch Actions is not enabled then the response will not work as expected. If you have Comfort I Firmware < 4.233 and you nbeed to code aq complex nested If/Then Response, then you are advised to get a firmware upgrade to 4.234 which is the last released Ultra I firmware If SecurityMode = SecurityOff Then AutoArm AwayMode Else If SecurityMode = AwayMode Then If AlarmState < Alarm Then AutoArm SecurityOff End If End If If SecurityMode = NightMode Then If AlarmState < Alarm Then AutoArm SecurityOff End If End If If SecurityMode = VacationMode Then If AlarmState < Alarm Then AutoArm SecurityOff End If End If End If Last edited on Wednesday Sep 16th, 2009 11:31 am by ident |