Comfort Automation/ Security System Forums > Support > FAQs - Technical > Upgrading Comfort I to Comfort II - Module Compatibility |
Moderated by: admin | Topic closed |
Author | Post | |||||||||
---|---|---|---|---|---|---|---|---|---|---|
ident Administrator
|
Which of the old Comfort modules can still be used with Comfort II? We try to give a complete list of modules here In general most modules which are connected to the Comfort RS485 Bus, ie keypads, door stations, UCMs, SCS, RIO are compatible with some limitations
Last edited on Wednesday Jul 10th, 2019 12:33 pm by |
|||||||||
ident Administrator
|
The CM9000 PCB should be mounted on the AC-PLATE01 which will have the same mounting holes as Comfort 1 Photo below shows how the Comfort 2 PCB sits on the metal plate via the plastic standoffs which are supplied Accessory pack with plastic standoffs and other resistors and cables Take note of the connections to the Comfort 1 PCB and reconnect them to the new PCB The Hookup diagram can be downloaded from http://www.cytech.biz/hookup_diagram.html?category_id=106 This shows the connections Download the Comfort 2 manuals from http://www.cytech.biz/manuals.html and read carefully If you have the old ccl or cclx file, open in Comfigurator 3 and convert to the correct version, Comfort 2 Ultra (or Optimum depending on which model you have) Check your program and write to Comfort and test. You can use a UCM or KT03 USB port to wrote to Comfort |