Moderated by: ident
Topic closed
Author Post
admin
Administrator
Joined: Saturday Mar 3rd, 2007
Location: Singapore
Posts: 1200
Status:
Offline
back to top
2.0.6 (Dec 2007) Supports Pulse Output action. Previous versions do not support Pulse Outputs
2.0.4 (March 2007) CBUS2 IR Codes supported, mapped in IRReceive codes 0-31. Adjusted IR Receive algorithm to match new IR Receiver characteristic.
2.02 (May 2005) Fixed Bug in previous versions where noise on an input may cause the RIO to lock up until the input is triggered again
2.0.1 (June 2004) Fixed IR Transmission can transmit IR 0 to 255. Fixed bug could only transmit 0-15
2.0.0 (Dec 2003) - Upgraded processor. Transmit IR 0 to 15 only. IR Transmit buffer increased from 64 to 96
The Firmware history is also documented in the RIO Manual
Last edited on Saturday Jun 14th, 2008 05:47 am by admin
segurant
Member
Joined: Wednesday Mar 19th, 2008
Location: Santarem , Portugal
Posts: 6
Status:
Offline
back to top
The temperature sensor in the SCS I think it is not good solution. Is necessary included an SCS for to access the temperature sensors. An excellent solution I think is the creation of a new RIO (RIO02) with 8 inputs and 8 outputs analog (0 - 10V), so we can place sensors of temperature, light, humidity, etc..
Best Regards
Miguel Antunes
ident
Administrator
Joined: Wednesday Aug 9th, 2006
Location: Singapore
Posts: 3493
Status:
Offline
back to top
Lets move this topic to the RIO forum http://www.comfortforums.com/forum84/1669.html
Parts of this bulletin board may not function unless you enable JavaScript (also called Active Scripting) in your browser.