nigelgiddings
Member
Joined: | Thursday May 8th, 2008 |
Location: | |
Posts: | 5 |
Status: |
Offline
|
back to top
|
I have recently connected the Tel IN and Tel OUT connections of my Comfort system in line with the outside line.
I also have a Meteor CID device which I use in conjunction with the xAPTel application which has worked very well up until now.
It now looks as if I connect the Meteor on the Tel IN side of the connection it does not work properly, If I connect it on the Tel OUT side it seems OK. See below:
Line -- ADSL Filter -- Meteor -- Tel IN Tel OUT -- PBX (Meteor does not work)
Line -- ADSL Filter -- Tel IN Tel OUT -- Meteor -- PBX (Meteor does Work)
NB the Meteor is not strictly 'in-line' it is 'T-ed' accross the line at the point shown.
While the Meteor would capture all incoming calls irespective of position I was hoping to monitor outgoing calls made by Comfort (The Meteor monitors both i/c and o/g calls).
I wonder if there is anything between the Tel IN and Tel OUT connections that might interfere with the device? Has anyone else experienced similar?
TIA
Nigel
|