Comfort Automation/ Security System Forums > Support > Comfort Installation and Programming Guide > Security System Programming > Programming a Zone to announce |
Moderated by: slychiu | Topic closed |
Author | Post | |||||||||
---|---|---|---|---|---|---|---|---|---|---|
slychiu Administrator
|
A zone can be programmed to announce on the keypads whenever it is triggered. This is not referring to Walk test, which is a test mode in which all zones are announced when triggered. To program a zone to announce, Assign a Response with action Say ZoneName in the Zone Response (using Response Wizard in Comfigurator) The Zone Response is activated whenever the zone is triggered (eg door open or Movement detected). The Say Zone Name action will cause the programmed zone name to be announced The Response can be smarter, eg it can announce only at certain times eg If Hours >= 7 And Hours < 22 Then Say ZoneName End If An example file is attached Zone 1 will will announce when open Zone 2 will announce only from 7 AM to before 10 PM This will announce the zone only between 8 PM and 6 AM Comfort Responses has powerful conditional programming to allow for almost any situation Attachment: announcezone.zip (Downloaded 18 times) Last edited on Tuesday May 31st, 2011 01:43 pm by |
|||||||||
ident Administrator
|
Comfigurator 3.6.x Zone Settings has an "Announce" Checkbox When checked this zone will anounce its own name when the zone is opened This requires Comfort firmware 7.009 and above The action announce zone is needed only for conditional announcements Last edited on Monday Aug 5th, 2013 02:23 am by |