View single post by Glouba | |||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Posted: Wednesday May 4th, 2011 09:56 am |
|
||||||||||||
Glouba
|
Thanks for the fast reply. I'll try writing a 1bit value then. I'm almost sure I already tried before. So you mean that if my "Bypass Zone 1" is set to group address 1/1/1, if I bypass the zone with the comfort keypad, comfort will trigger a message on the KNW bus saying that 1/1/1 is set to 1 ? I didn't notice that with the ETS group monitor when setting the bypass with the keypad. I'll run some more tests tonight. Thanks again.
|
||||||||||||
|