View single post by slychiu
 Posted: Friday Dec 31st, 2010 01:56 am
 PM  Quote  Reply  Full Topic 
slychiu



Joined: Saturday Apr 29th, 2006
Location: Singapore
Posts: 5493
Status: 
Offline

  back to top

UCM/Cbus 5.208
  • Security Armed State will have values 1 to 4 depending on security mode instead of common 1 when armed.
  • If zone is bypassed at UCM/Cbus reset, this is reported to to Cbus.
  • Multiple Cbus  messages can be received and handled.
  • Existing Line cut, AC Failure and  low battery alarms are notified to C-Bus when C-Bus is connected to  Comfort.
  • Zone states are reported to Cbus when Cbus is connected
  • Faster initialisation of Cbus interface especially when the Security Application is not present on the C-Bus (eg C-Touch)
  • Fixed bug when Cbus addresses > 128 not reported correctly
  • Added STOP ramp SAL command,  handle Label DLT message
  • Messages to C-Bus larger than 45 bytes (concatenated messages) are aborted in keeping with the Cbus serial interface spec.
  • Security Application Password Good/Bad supported
Bugs
  • Sending commands to other applications besides Lighting will update the counter related to the group address.
Note: UCM/Cbus firmware 5.208 and below  not work with new Cbus SIM Daughterboard with ST7 micro pictured below



This firmware UCM 5.208 and below should onlybe used  with SIMs labelled 1223/x, and  1151/x as shown below

Attachment: CBUS5_208.zip (Downloaded 1 time)

Last edited on Thursday Mar 17th, 2011 01:45 pm by

 Close Window