View single post by ident | |||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Posted: Tuesday Aug 10th, 2010 06:26 am |
|
||||||||||||
ident
|
Please note that the 6 way UCM Programming cable shown below should NOT be connected between the UCM and the Comfort PCB in normal operations. It should be connected ONLY when doing a Firmware Upgrade using the UCM. If this programming cable is connected between the UCM and Comfort, it will put Comfort into Firmware Uograde Mode and the system will not be operational Attachment: Ucm_cable.jpg (Downloaded 52 times) Last edited on Tuesday Aug 10th, 2010 11:39 am by ident |
||||||||||||
|