back to top

• Size 108 x 88 mmm UCM baseboard with C-BUS SIM (Serial Interface Module) daughterboard.
• Power Supply: 12V 30 mA (supplied from Comfort)
• Connected to C-BUS via bus cable (2 wires).  Comfort is electrically isolated from C-Bus.
• Supports  Lighting, Security, Clocks/Timekeeping, Enable, Trigger, Measurement Applications
  
• Synchronizes the date and time between Comfort and C-BUS via the Time/Date Application.
• Comfort implements the C-Bus Security application.  Comfort automatically sends Alarm information  which can be displayed on C-Touch. The following status messages are supported: Armed/disarmed, Exit Delay Started, Entry Delay Started, Alarm Active, Tamper active/Inactive, Panic Active, Battery Status, Status Reports 1 & 2. The following Security Control messages are supported: Arm system, Activate/deactivate Tamper, Activate Panic, Emulate Keypad, Status 1 and 2 Request.
  
•  C-Touch can simulate a keypad allowing entry of user code and arming/disarming of Comfort.
• Maps Cbus group addresses in supported applications to Comfort Counters, sensors, Flags, Virtual Inputs, Physical Inputs, Outputs

• UCM /C-Bus2 Module with firmware version UCM/C-Bus2 version 7.045 or above.
  

1. Comfort firmware Version 7.xxx
2. UCM/USB or ETH firmware version 7.xxx
3. UCM/CBus2 Firmware 7.042 (Beta)
   
4. Comfigurator 3.8.5 or above. Download from http://www.cytech.biz/comfigurator.html

Last edited on Tuesday Jun 24th, 2014 04:54 pm by