| PM | Quote | Reply | Full Topic |
| Joined: | Saturday Mar 3rd, 2007 |
| Location: | Singapore |
| Posts: | 1200 |
| Status: |
Offline
|
Whenever Comfort sends any data to Cbus you should see the BUSY2 LED blink If it does that, it means the information has been transmitted to Cbus. There is also an acknowledgement from the bus otherwise the BUSY2 will remain on, and the ERR
You can verify that by disconnecting the Cbus cable and sending some info
If the BUSY2 and ERR remain off then Comfort has sent its data successfully and something on the Cbus is preventing the devices from receiving
| Close Window |