View single post by Campbell | |||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Posted: Thursday Jan 29th, 2009 08:54 pm |
|
||||||||||||
Campbell
|
Many thanks... Took your advice and reviewed the panel and connections... there is only 2 pins marked TR and COM What threw me was beside the third (missing pin) screw connector , the pcb had 0v printed on it....currently the third screw connects the bellbox tamper to the panel tamper in series, the com supplies -12v hold off..it is wired correctly if only I had noted it in 1999 I wouldn't have had same problems.. I've sketched out my intended 2 off Cequras in parallel (tamper in series on the pdf linked below.. http://www.cmacd.org/comfort/Cequrax2.pdf Any comments appreciated Campbell
|
||||||||||||
|