View single post by marinoss | |||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Posted: Monday Nov 5th, 2007 09:14 pm |
|
||||||||||||
marinoss
|
We have not managed to establish communication between Comfort Generation Two and the EIB network: After connecting the UCM the D4 “ERROR†(Red) is off. D1 “RDY†(Green) is on at all times while the D9 & D10 blinks as expected. After some time (30-45 minutes ) the D4 turns on. After we disconnect and reset the UCM it goes off but then on again after some time. Also we have not managed to send telegrams although a simple response was programmed and activated via the Control Menu. The D3 does not come on. In addition the D2 “BUSY1†(Red) does not blink when there is an incoming telegram from a monitored Group address. We double checked the polarity and everythings seems fine. Thanks in advance.
|
||||||||||||
|