Comfigurator 3.13.9- Fixed Bug – Modbus Slave addresses for Bypass Inputs were not corrected
- Fixed Bug The KNX/Modbus EEPROM write had an issue with the comment text for the Modbus->Comfort failing to write
- Fixed Bug IRIO properties is that maximum setpoint can go lower than minimum setpoint. Although there are checks implemented, they fail when up and down buttons are used.
- ISM09 default temp offset reporting should be 0 not 1
- USB drivers have been updated in C:\Program Files\Cytech Technology\Comfigurator\USB Drivers
Known Bugs- The action Set Virtual Inputs On/off is able to select a virtual input to turn on or off
- If UCM ID=1 is not connected, scanning for Modules using ETH03 plugged in to the CM9001 or UCM with ID 2 onwards, the UCM Module will show ID1 Firmware 255.255 OTHER see http://www.comfortforums.com/forum20/5435.html
Last edited on Sunday Aug 6th, 2023 02:20 am by slychiu
|