Ian
Joined: | Saturday Aug 19th, 2006 |
Location: | United Kingdom |
Posts: | 249 |
Status: |
Offline
|
back to top
|
I have added a couple of z-wave window sensors to my z-wave network. I want to add them to comfort as part of the alarm system.I did the usual 'learn' procedure and after a couple of attempts it started to learn. Then Comfigurator stopped learning and the primary controller showed an error message.I tried again but nothing is happenning.Now I see an error in red in the bottom left of the Comfiguratot window; Communication error between UCM baseboard and Z-wave sub-module.I have restarted both Comfort and the primary controller (HomeSeer)
Any suggestions of what may be wrong?Comfort 2 UltraZ-wave module
|