View single post by daniedb | |||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Posted: Monday Apr 5th, 2021 12:54 pm |
|
||||||||||||
daniedb
|
My previous board before I tried to upgrade was a UCM/ETH02 board. I have tried to use the old UCM (firmware 7.141) with the new ETH03 submodule, but I still get a connection error. I must assume that the new UCM/ETH03 board is corrupted. Very frustrating. I am using currently the ETH02 board else I cannot connect to the system, but need to move to ETH03 to be able to do Vocabulary upgrades. When installing the ETH03 submodule on the previous UCM base board do I need to remove the UCM module from the Comfigurator config and then scan for it again or can I simply continue on the same UCM config definition?
|
||||||||||||
|