View single post by 111rdw | |||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Posted: Wednesday Feb 24th, 2021 03:23 pm |
|
||||||||||||
111rdw
|
I'm trying to avoid running a wire to a door by using a Z-Wave door switch. I cannot understand after many readings of the manual and forum posts how (if it is even possible) how to do this. I can see the switch in the z-wave mapping but then it all gets a bit confusing to me - I'm an amateur at this. If this is possible what do I need to do? thanks in advance Last edited on Wednesday Feb 24th, 2021 03:24 pm by 111rdw |
||||||||||||
|