| PM | Quote | Reply | Full Topic |
| Joined: | Wednesday Jul 12th, 2006 |
| Location: | United Kingdom |
| Posts: | 788 |
| Status: |
Offline
|
So in the example given.... Go to any keypad and you will have the same menu format read out....
Go to keypad 1 (assumed to be partition 1) and press 0; 1; 1 in the menu and output 1 pulsed ( opens say a garage door)
Go to keypad 2 or greater (assumed to be another partition other than 1) and press 0; 1; 1 in the menu and output 3 goes on ( opens say a gate permanently open)
So this may work but the practicality is a nonsense.
Take a scenario where the menu has a proper labelling structure e.g. gate open.
On keypad 1 it would open the garage door.
On keypad 2 it would open the gate!
If you had not put the Else command in then On keypad 2 nothing would happen !
| Close Window |