View single post by slychiu | |||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Posted: Saturday Oct 31st, 2020 04:49 am |
|
||||||||||||
slychiu
|
Using Comfigurator Use Comfigurator software 3.13.5 or above to configure Wifi01. Download from http://www.cytech.biz/comfigurator.html Go to Menu > Options > Settings > UCM Interface and select Wifi from the drop-down list as shown below. Select Wifi and click on Wifi Configuration. Fill in the fields required
Soft AP mode allows your computer to make an initial connection to Wifi01 so that the Wifi01 settings can be written to it. In Soft AP mode the red SOFTAP LED will flash, as well as the Green IP LED.. Look for the SSID eg Gecko OS Web Setup xxxxx, and connect to it. Enter "password" when asked for the passkey When connected to the Soft AP SSID, press OK. If succesful, you should see the screen below. Press OK to acknowledge. Press "Copy to Clipboard" if there is a problem, to investigate the setup. Send to support@cytech.biz for assistance if necessary. After pressing OK, Soft AP mode is disabled and the Soft AP SSID should no longer be seen. The Soft AP Mode is ended, and the Wifi01 will be a station on the Wifi network On the Wifi01, the green IP LED should flash slowly if it has joined the network. It will blink fast if the Wifi01 is not part of any network. If necessaey press the RESET button on Wifi01 On the Wifi01, the green IP LED should flash slowly if it has joined the network. It will blink fast if the Wifi01 is not part of any network. If necessaey press the RESET button on Wifi01. Last edited on Saturday Nov 14th, 2020 02:42 am by slychiu |
||||||||||||
|