View single post by Sota
 Posted: Monday May 11th, 2020 09:15 pm
 PM  Quote  Reply  Full Topic 
Sota

 

Joined: Friday May 3rd, 2013
Location: Galway, Ireland
Posts: 62
Status: 
Offline

  back to top

I'm a bit confused about my expansion options using a Slave Expansion Module as there seems to be several different variants, and I want to make sure I get it right before ordering.My current system is a CM9000 with firmware 7.160. I have a UCM/ETH03 and a UCM/Pi. Also in the same box is an LEM03-M2 giving a total of 24 inputs and 8 outputs. I also have a spare LEM01-M2 with 8 inputs and 8 outputs. I only need additional inputs for the extra zones I am installing.
Some posts seem to imply that I cannot add an SEM with an LEM03 in the system, while elsewhere it says it can be installed in the last SEM only - which is correct?If the LEM03 can be used, then I propose moving it to the SEM and installing the spare LEM01 in the CM9000.In that case, can I use the SEM01C, as I won't need any more inputs and I would prefer to use the switch-mode PSU.
So, I think I need the SEP01C, which is the case + SEM + PSU. Sorry for being long-winded about this but I don't want to order the wrong parts.Thanks.

 Close Window