back to top

• KP04AT Internal Temperature sensor field Read froom KP04 is not correct, does not update the sensor
  
• Cbus Custom application 1 and 2, when Read from Cbus EEPROM, values of FF give exception.
  
• Divide Action 157 shows Wring Parameters in Response Wizard
• Old BUG-  The "OR" condition in a Response is incorrect after a Read from Comfort  (old bug)

• Action Code Counter clear and set  158,0 and 1 were reversed
• KNX/Logic – when UCM/GSM4 is connected, scan gets exception
• UCM/Logic add UCM give exception (not connnected to system yet)
  
• Slave 1 comms failure is reported as Door station -15 in status bar
• When connecting to a Comfort with a different vocabulary from the cclx file, Comfigurator detects the vocabulary correctly, but when selecting words, the wrong wordlist is used (according to the cclx file, not Comfort). However after saving the file and opening again, the correct vocab is used
• KNX/Logic gets exception when UCM/GSM4 was connected
  

• UCM/Modbus – allow different modbus id on each Modbus to Comfort line.
  
• Added Action 160 s12V timed off to turn off S12V for programmed duration. (requires New Comfort Firmware to be released)
  
• Added Subtract action 149, 3  subtract Immediate  Action. (requires New Comfort Firmware to be released)
• Added Set user partition action 161 (requires New Comfort Firmware to be released)
• Ucm/Pi module tab added virtual input assignment. If UCM/Pi is already in the configuration, delete and add it again to see the new Virtual Inputs tab
  
• CM9001- EMS Sensors calibration allow decimal fraction (requires New Comfort Firmware to be released)
• KP04AT temp sensor  - KP Internal Temp Sensor field for KP04AT with temperature sensor
  
• C-bus 2 custom applications 1 and 2. Requires new UCM/CBUS2 Firmware (to be released)

Last edited on Saturday Mar 28th, 2020 04:37 am by slychiu