View single post by palmlodge

Posted: Sunday Nov 3rd, 2019 01:00 pm

Joined:	Thursday Dec 14th, 2006
Location:	United Kingdom
Posts:	507
Status:	Offline

Yes, I can scan for modules, that seems to work as it did before. Comfort to CBUS is still working, but Comfort input detection doesn't fully appear to work correctly across the board.

I'll send the config file now. This config file was working before the firmware update.

I also just tried loading Comfigurator with NO config, performed a selective READ on just the zones/inputs, then attempted a selective WRITE on just zone/inputs. Counter stopped at 2% and Comfort reset itself, so this doesn't appear to be my config that's at fault?

Last edited on Sunday Nov 3rd, 2019 04:04 pm by palmlodge

Close Window