View single post by david8811 | |||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Posted: Monday Nov 19th, 2018 05:03 am |
|
||||||||||||
david8811
|
http://www.arduinostarterskit.com/sale-7641832-lightweight-four-channel-relay-module-for-arduino-red-board.html I am trying to wire up my Comfort Output to my 4 channels Relay to switch on the light in the event of PIR is being activated. Refer to above link for details of my 10A 250V relay. How do I connect the output and 12v from Comfort panel to the relay input? Q1 Is it correct to connect the 12V of the Output to DC+ of the relay module? Q2 then connect the OP1 of the Ouput to IN1(Input 1 ) of the relay? And accordingly OP2 to IN2 and so on? Q3 How about the DC- of the relay? Where to connect to or leave it unconnected? Would appreciate your support and sharing. Last edited on Monday Nov 19th, 2018 05:04 am by david8811 |
||||||||||||
|