View single post by Swiss-Toni | |||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Posted: Monday Aug 13th, 2018 11:16 am |
|
||||||||||||
Swiss-Toni
|
Hi Slychiu The firmware is all up to date, the only workaround for this problem is when the sensitivty is set at 200ms or above, this issue only seems to be affected on the SEM, not on the main comfort panel, everything works as it should until you try to use a lower setting, it does not affect the function of most contacts but does seem to cause a conflict when I tried to connect up my PIRs on the SEM with a digital signature set at 50ms any other equipment behaved normaly even when the zone reported active! The only way i could describe it would be: Sensitivity set between 50ms and 200ms Door closed: (shows as active) Door open: lights turn on (shows as active) Door closes: lights turn off (shows as active) When sensitivty set at 200ms & above Door closed: (shows as inactive) Door open: Lights turn on (shows as active) Door closes: lights turn off (show as inacvtive) It's no longer an issue for me as the sensitivity has been set at 200ms and above and the problem was resolved on my personal system.
|
||||||||||||
|