View single post by timop001 | |||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Posted: Monday May 21st, 2018 10:51 pm |
|
||||||||||||
timop001
|
Upgraded to Gen2 board. As was setup on the Gen1 board, Output 16 on a LEM is connected to external status LEDs (and set as as a "Status" output in Comfigurator). LEM is upgraded too. On the Gen1 system, these LEDs used to flash in a Alert state (say on entry delay) but now just show "armed" or "off" - no alert flash even though the keypad status LED may be flashing. Is this a Gen2 design or have I missed something obvious ?
|
||||||||||||
|