back to top

1. Date and Time from KNX (when mapped to KNX) did not get sent to Comfort
   

1. Fixed Bug - bypass zone to KNX did not work
2. Fixed bug on Bypass zones to KNX
3. Fixed bugs in security modes to KNX.
4. Fixed bugs in EIS10 2 byte counter, EIS5. sFixed bugs in EIS10 2 byte counter, EIS5.
5. Fixed BUG: Action send command to KNX does not update Comfort register which is mapped to the KNX address

1. Even if counter> KNX 1 bit programmed, send to KNX > Comfort 1-byte group address if present. Even if counter> KNX 1 byte programmed, send to KNX > Comfort 1 bit group address if present
2. When sensor value changes, send sensor value to mapped KNX address KNX to Comfort mapped to Comfort sensor.
3. When security mode changes, send value to KNX to Comfort for security mode group address.
4. Added Status Message  "invalid physical address"
5. UCM/KNX2 Status Error will appear if no confirmation for telegram to KNX.
   
6. Improved status report to Comfigurator
7. If no EEPROM, flash ERR LED
   
   
   

Last edited on Sunday Jul 21st, 2019 03:49 am by slychiu