View single post by eborges | |||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Posted: Tuesday Jun 6th, 2017 04:49 pm |
|
||||||||||||
eborges
|
Hello I have 21 motion detectors connected to Comfort and during normal house activity it causes a lot of traffic on the KNX bus and delays on the transmission of information from Comfort to KNX. I would like to skip the sending, from Comfort to KNX, of the status report for the motion sensors but still receive information of the non-motion sensor zones. Is there a way to selectively report zone status to KNX bus ? ( by the way in the 'UCM/KNX2 - Comfort to KNX Interface' pdf manual in page 27 it is referred "In the screen shot above, the zone status is assigned to Group address 0/1/1." but there is no such screenshot . Please correct manual) Regards Eurico
|
||||||||||||
|