View single post by slychiu | |||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Posted: Thursday Mar 16th, 2017 09:27 am |
|
||||||||||||
slychiu
|
Hi David The General UCM used for Programming firmware is only 5.192 see attached screenshot It needs to be upgraded to the latest version 7 However for version 5 UCM firmware you need to have another UCM to upgrade this ucm using the UCM programming cable see http://www.comfortforums.com/forum4/1782.html When it has been upgraded to UCM firmware version 7, then this UCM can be used to upgrade Comfort ansd the UCM/KNX2 without the programming cable, just use Comfigurator If you do not have another UCM/USB or ETH03 perhaps you can borrow a UCM or ask Vestereme to to the upgrade for you By the way you cannot paste an image onto a post in the forum, it will not accept it and will display garbage Attachment: Capture.JPG (Downloaded 20 times)
|
||||||||||||
|