| PM | Quote | Reply | Full Topic |
| Joined: | Saturday Apr 29th, 2006 |
| Location: | Singapore |
| Posts: | 5499 |
| Status: |
Offline
|
Does your UCM05 have a serial 9 way connector and the USB01 is pluuged in on top?
If so you have to set the J2 shunt in the "485" position and not the "232" position
The J2 jumper is blow the 9 way serial connector
You should upgrade the Comfort and SEM firmware to the latest firmware
I believe your UCM 5.200 should be able to do this using the UCM Firmware cable. see instructions in http://www.comfortforums.com/forum4/1216.html This may allow the SEM to be scanned
However the UCM cannot upgrade itself and the old UCM01 cannot be used
You can ask Laser if they will help to get it upgraded for you
If you have converted the cl file to cclx you should not need to enter the sensors and zones agaim If PIRs are connected to a single zone then you cannot differentiate them, so it is always advisable to have a PIR in its own Input/zone
| Close Window |