View single post by admin | ||||||||||
---|---|---|---|---|---|---|---|---|---|---|
Posted: Saturday Dec 24th, 2016 12:47 pm |
|
|||||||||
admin
|
HIO01 Properties Room ID Each HIO is assigned a ROOM ID in the range 1 to 15 or FF for Unassigned (default). The room ID is used when 2 or more HIOs in the same network are part of the same room eg a Suite in which case the Room ID for the HIOs should be set to the same number. The HIO with a Room ID reports changes in Scene, Keycard, MUR, DND, PIR, Door sensor, Doorbell, Occupancy. The controller will broadcast the changed state using ID 0. Other HIO in the same network with the same Room ID will act on the broadcast commands on its own inputs and outputs Light off Dim Level LED level when the light is OFF, 0 means off, 63 is full bright. This is the LED dim level when when the Light is OFF and led is off state. The dim level is supposed to help the guest to find the light switch when the lights are off. Share Switch Input/LED Output Pin The HIO Input can be shared with the LED Output so that the same I/O pin can read the Input state as well as drive the LED on the ELV switch if the ELV switch is designed with shared I/O pins. This reduces the number of connections on the ELV switch to 1 signal per Switch/LED. If the Switch Input does not have an LED, then disable this option. If disabled, the I/O pin will be an Input pin only. Occupancy Indication by Doorbell Occupancy Indication by doorbell - Pressing and holding Doorbell for 6 seconds will allow occupancy to be shown on MUR/DND. Doorbell pulse in 100 ms units when Occupancy detection by doorbell is on. If Occupancy Indication by doorbell is disabled, and the doorbell output directly follows the doorbell Input Master Switch Setting This determines what happens when the Master switch is pressed when its state is OFF. If NO Action is selected, the Master switch is for Master OFF only. Temperature Sensor Name Map the Temperature obtained from the Thermistor input to a Sensor Register for monitoring by Controller (optional) Blinds Operation Mode Follower: Output follows Input press. Pulse: pressing the Input button produces a fixed Pulse on the Output according to Blinds Pulse Duration. If Pulse is selected, value is Pulse width for Blinds in Pulse Mode in 100 ms units Keycard Off Timer Delay to switch off ELV lighting channels, Primary & Secondary relay after keycard is removed. Primary Relay Occupancy Timer Delay after door is closed to turn off Primary relay and ELV lighting channels if PIR does not detect motion in Occupancy Sensing Mode. Secondary Relay Occupancy Timer Delay after Door is closed to turn off Secondary Relay if PIR does not detect motion in Occupancy Sensing Mode. Lighting Occupancy Timer Delay after Door is closed to turn off Lighting ELV channels if PIR does not detect motion in Occupancy Sensing Mode. Courtesy Timer Delay for Courtesy Scene before it switches off if keycard is not inserted or motion not detected. Boot-up Timer Delay after power On before operation starts to allow sensors to settle. Window Timer Delay after window is opened before the Keycard output or Primary Relay output is switched off Lighting Sequence Timer When Lighting Occupancy Timer Expires, this is the delay between each light turning off in sequence instead of all lights off at once Last edited on Saturday Dec 24th, 2016 12:47 pm by admin |
|||||||||
|