View single post by admin
 Posted: Saturday Dec 24th, 2016 01:17 pm
 Full Topic 
admin



Joined: Saturday Mar 3rd, 2007
Location: Singapore
Posts: 1200
Status: 
Offline

  back to top

Use the Comfigurator software version 3.11.10 or above to configure HIO01. The software can be downloaded from  http://www.cytech.biz/comfigurator.html
One of the following equipment is needed to configure HIO01;
  • UCM/LOGIC with plug in ETH03 or USB interface. UCM/Logic is a controller and UCM on one product.
  • Logic Engine LGX01 with UCM/USB or UCM/ETH03
  • Comfort CP9000 with UCM/USB or UCM/ETH03
Run Comfigurator, go to the Modules Tab and right-click on the HIO folder as shown below.


“Scan for HIOs” to detect any HIOs in the network if the IDs is set correctly without any conflict with other HIOs.

“Add HIO” allows you to manually add an HIO if not currently connected to Comfort, i.e. when doing programming off-line.

The result of scanning or adding a HIO  is shown below for HIO Id 1. The new HIO is seen on the middle and right panes.




IN HIO Properties on the right;
  • “ID” is the ID of the HIO from 1 to 15
  • “Name” is any text description for the HIO used to identify it.
  • “Type” is the HIO Type, HIO01
  • “Version” is the HIO firmware version which in this example shows 7.000. If the HIO was manually added instead of being scanned, the firmware information will not appear.
  • “Latest Version” is the latest release version available when internet connection is present.
  • “Serial Number” is the electronic serial number of  the HIO, if any.

In the middle pane, “Status” shows the status of the HIO. It is ‘Polled’ when the HIO is detected and matches the number of HIOs programmed in the system. ‘Not Polled’ will be displayed when the HIO is detected by scanning but the number of HIOs programmed is less than the HIO Id. ‘Not Found’ is shown when the HIO is added to Comfigurator but is not connected to the controller when scanning is done.
Click on the HIO01 text below the HIO folder to show the HIO configuration screen shown below;





Menu Bar
The  menu items are; Write to HIO01, Read from HIO01, Reset to Default,  Get Status. Save Template, Load Template

Write to HIO01
This writes the tables into the HIO

Read from HIO01
This reads the data from HIO and displays  the data on screen

Reset to Default
This  clears all the data in the tables  to default, but does not write any data to HIO.

Get Status
The Get status button causes the HIO status to be shown on the status bar on bottom left, for example,
"Normal/No error"

When the cursor is moved away from the HIO screen, Get status is automatically turned off, and when the cursor is on the HIO screen the get status function is turned on if Comfigurator is logged in.

Last edited on Saturday Dec 24th, 2016 03:23 pm by admin
 Close Window