View single post by John W | |||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Posted: Monday Aug 22nd, 2016 11:07 pm |
|
||||||||||||
John W
|
Hi, Bit of a problem here.I upgraded to comfort 2 pcb, and converted the previous config file to comfort 2 ultra format. I saved the file and all seemed fine. It uploaded to the new board too (checked each zone in engineer mode). There were two issues (see below) but generally it's fine. After the above I then did a whole load of updates for the control menu, and added the irio configuration. This was again saved, but not uploaded as the irio isn't connected yet. Tonight I have fired up comfigurator, selected the file, and got the above. I have opened the file in notepad and it generally looks ok (I don't have the schema so can't validate it against that). On a different subject (so probably needs a different topic, unless it's related):
Thanks in advance. Last edited on Tuesday Aug 23rd, 2016 12:23 am by John W |
||||||||||||
|