| PM | Quote | Reply | Full Topic |
| Joined: | Saturday Apr 29th, 2006 |
| Location: | Singapore |
| Posts: | 5495 |
| Status: |
Offline
|
A UCM/USB, UCM/Ethernet, or UCM/Logic is required to connect to the computer running Comfigurator.
Run Comfigurator, go to the Modules Tab and right-click Controller or Sensor folder symbol as shown below. Select Scan for All Modules or Scan for Sensors. This will scan the network for TSM01.
“Add Sensor†allows you to manually add a TSM01 if not currently connected to Comfort, i.e. when doing programming off-line.
The result of scanning or adding a TSM01 is shown below .
Sensor01 appears on the left pane and the summary properties is shown on the right pane. Click on Sensor01 on the left pane to show the Properties of the TSM01 as shown below;
Sensor Properties
“ID†is the TSM ID 1 to 15
“Name†is any text description for the TSM used to identify it and serves no other function.
“Type†is the Sensor Type
“Version†is the firmware version which in this example shows 7.001. If the TSM01 was manually added instead of being scanned, the firmware information will not appear.
“Latest Version†is the latest release version available when internet connection is present.
“Serial Number†is the electronic serial number which is not used at present
“Status†shows the status of TSM01 It is ‘Polled’ when the TSM is found in the network and is polled. ‘Not Polled’ will be displayed when the TSM is detected by scanning but the number of TSMs programmed is less than the TSM01 Id. ‘Not Found’ is shown when the TSM01 is not connected to Comfort when scanning is done.
Last edited on Sunday Nov 13th, 2016 10:35 am by slychiu
| Close Window |